Jack JK-T1790, Manual

Page: 54 / 185

- 47 -
NO.
项目
Item
设定范围
Setting range
编辑单位
Edit unit
备考
Remarks
S12
左锥形加固对称
Flow bar-tacking offset, left
设定为了形成锥形加固形状的加固部的长度。
This item sets length to form bar-tacking section of flow bar-tacking
shape.
0.00
～
3.00 0.05mm ---
S13
右锥形加固对称
Flow bar-tacking offset, right
设定为了形成锥形加固形状的加固部的长度。
This item sets length to form bar-tacking section of flow bar-tacking
shape.
0.00
～
3.00 0.05mm ---
S14
圆眼形状长度
Eyelet shape length
设定圆眼形状的圆眼孔中心到上侧的长度。
This item sets upper side length from center of eyelet of eyelet shape.
1.0
～
10.0 0.1mm ---
S15
圆眼形状针数
Number of stitches of eyelet shape
设定圆眼形状的上部
90
度中的缝制针数。
This item sets number of stitches in the upper 90
ﾟ
of eyelet shape.
1
～
8 1 ---
S16
圆眼宽度
Eyelet width
设定圆眼形状的内侧的横尺寸。
实际的落针点是加上
S04
左切刀槽宽度后的尺寸。
This item sets crosswise size of the inside
of eyelet shape.
Actual needle entry point is the dimension to which
S04 Knife groove width, left is added.
1.0
～
10.0 0.1mm ---
S17
圆眼长度
Eyelet length
设定圆眼形状的内侧纵尺寸。
This item sets lengthwise size of the inside of eyelet shape.
1.0
～
10.0 0.1mm ---
S18
圆型形状长度
Round type shape length
设定圆型形状的中心到上侧的长度。
This item sets upper side length from the center of round type shape.
圆 型 上 放射上 半圆上
圆 型 下 放射下 半圆下
Round type, top Radial, top Semilunar, top
Round type, bottom Radial, bottom Semilunar, bottom
1.0
～
5.0 0.1mm ---