4
9
CLEANING YOUR
POWER JUICER EXPRESS
• Turn off the power switch and wait until the motor completely stops.
• With dry hands, unplug the power cord from electrical outlet.
• Disassemble the machine. (See disassembly instructions.)
• See instructions below for cleaning juice spout.
• Wipe base with a soft damp cloth or sponge. Do not submerge base in water. Do not spray with water or
any other liquid.
Base is not dishwasher safe.
• We recommend washing the pusher by hand in warm soapy water. Due to temperature differences in
dishwashers if you choose to wash the pusher in the dishwasher, place it on top rack only.
• Clean all other parts in warm, soapy water. A mild detergent is recommended. Rinse well and dry
thoroughly. All components are dishwasher safe with the exception of the base. Do not use in European
Import or a commercial dishwasher.
• To clean the filter and blade, hold them under warm running water. Use a soft-bristled dish washing brush
gently to completely clean pulp from filter. Rinse the filter from the outside under running water.
• Dry components thoroughly then assemble the machine and turn the power on to spin out any excess water.
• Make sure unit and parts are completely dry then store in a cool, dry place.
• We recommend removing juice spout after each use.
To Clean Juice Spout:
STEP 1:
Locate removable juice spout locking mechanism on
the bottom side of receptacle.
Note: Juice spout will be in the locked position.
STEP 2:
To unlock, turn locking mechanism counter-clockwise,
lining up notch with juicer spout hinge pivot arm.
IMPORTANT:
When reattaching juice spout back
into original position make sure juice spout is in the
locked position and tightly secured before use.
STEP 3:
Lift up juice spout carefully from receptacle
and remove to clean.
To Reattach:
insert juice spout back into original
position and turn the locking mechanism clockwise
to lock into place.
Locking
Mechanism
Hinge
Pivot Arm
LOCKED POSITION
UNLOCKED POSITION
HELPFUL HINTS
Obtain the best results from your Jack LaLanne Power Juicer
by following these helpful hints.
• Do not put any fruit or vegetables in your machine until power is turned on.
• Allow unit to run for at least 10 seconds before juicing.
• Do not force food into the juicer. Allow food to pass through slowly and steadily using the pusher. You do
not need to apply pressure unless the juicer starts to vibrate. Then only a slightly harder push should bring it
back to balance.
• Any fruit or vegetable that will fit the chute can be put through whole. The only time it is necessary to cut is
when something is too large. Then it should be cut into large enough pieces to fit in the chute. Do not cut
pieces too small.
• Remove large pits such as peach, mango, etc. as they will damage the blade and possibly the unit. Before
juicing cherries we recommend you remove the pits using a cherry pitter.
• Cleaning can be made easy by placing a plastic bag inside the pulp collector container. When you are
done juicing, the bag can be lifted out and disposed of easily leaving the pulp collector easier to clean.
• Let the Power Juicer run for a few minutes before turning off to allow any excess juice to be extracted from
the pulp. Once turned off it is quite normal for the juicer to spin for a minute or so due to the very fine
precision balancing of this appliance. Wait until it is done spinning before disassembling.
• Do not use bananas or avocados as they do not contain juice and will clog machine. Add them separately
in a blender.
• We do not recommend using overripe fruit as it will leave too much pulp in the filter and clog the machine.
• Do not pour liquids into the machine at any time.
SAVE THESE INSTRUCTIONS
ADDITIONAL SAFEGUARDS
The Power Juicer has a thermal cut-off safet y feature. If the unit accidentally overheats, it will stop working
temporarily until the Power Juicer cools down. Afterwards, the unit will continue to work again normally.
In the event the Power Juicer is jammed the motor may shut down. If this occurs the juicer should be shut off
and unplugged. The unit should be thoroughly cleaned to remove the obstruction. The thermal cut-off safet y
feature is designed to shut off the motor when it over heats.
Please use extreme caution when handling the Power Juicer blade as the blades are very sharp.
Always turn power off to the Power Juicer immediately and remove power cord from electrical outlet before
disassembling to clean due to any food obstruction.
CAUTION
Use caution when handling blade as blades are very sharp.
If juicer jams turn power off immediately and remove power cord from electrical outlet before
disassembling to clean.
The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop
working temporarily until the Power Juicer cools down. Clear any obstruction. Afterwards, the unit
will continue to work again normally.
