Lip
Pulp Guard
Chute
Locking Bar
5
Pusher
Filter/Blade
MAIN UNIT
(Fully Assembled)
Receptacle
Removable
Non-Drip Spout
Safety MicroSwitch
(Located on reverse side)
Base
Pulp
Collector
PARTS LIST
Lid with Built-in Pulp Guard
Locking
Bar
8
DISASSEMBLY
IMPORTANT:
Before disassembling the unit make sure you turn the power OFF
and unplug the machine from the electrical outlet.
STEP 2:
Lower the locking bar (silver) into position
as shown.
STEP 3:
Remove lid with built-in pulp guard by
pulling up off of receptacle.
STEP 1:
Remove pusher from the chute.
1
STEP 5:
Remove filter/blade/receptacle unit from base
by grasping the receptacle with two hands. Then
lift receptacle and twist in either a clockwise or
counter-clockwise direction while pulling in an
upward direction until filter/blade/receptacle unit
is separated from the main base.
Note:
Do not remove screws from blade. The filter
and the blade are one piece. They are not meant
to be separated.
STEP 4:
Remove pulp collector by sliding the
bottom away from the base in the
direction of the arrows while unhooking
from under lip on receptacle.
2
Chute
Pusher
Pulp
Collector
Receptacle
Lid with built-in
Pulp Guard
3
5
4
Pulp Collector
Base
Lip
Base
Receptacle
Lift and Twist......
