Mounting:
Horizontal
Mounting
Vertical
Mounting
Do Not Submerge
in Bilge Water
Installation:
1: Remove shipping plugs from the pump ports.
2: Connect hose to snap
fittings provided (A) and
strainer (B). Use 3/4”
(19 mm) braided reinforced
hose and a worm clamp
for hose connection to all
fittings.
3: Fasten pump to a flat
surface using grommets
provided. Do not over
tighten screws to allow grommets to absorb
vibration.
4: Insert Pumpgard
TM
strainer into pump intake port
(C). Insert outlet fitting to pump outlet. Snap the
clip closed to retain the strainer and fitting firmly in
the pump body.
WARNING – SAFETY PRECAUTION
This is a high pressure pump. Prior
to activation, ensure that the hose
clamps, discharge hose and snap
fittings are secure. The pump
must be properly anchored to a
solid surface.
Electrical:
Failure to follow the procedures below will void the
product warranty and/or cause possible harm to
persons or pump. In accordance with ABYC E-11,
AC and DC Electrical Systems on Boats guidelines.
Please reference Illustration A on fold out panel for
wiring instructions.
Operation:
1: Open seacock.
2: Open hose bib and/or pressure nozzle.
3: Turn on pump.
4: Close pressure nozzle/hose bib when water
runs free of air. Pump is now ready for automatic
demand operation.
5: For prolonged operation, pump must operate at
full open flow or motor will overheat.
NOTE: Do not operate longer than 15 min.
continuously!
(A)
(B)
(C)
