9
Why don’t I get sound in my headset when using my desk phone?
1. Verify that you’re your headset is switched on.
2. Verify that the base is connected correctly to the phone and that the power is on.
3. Verify that the link between the base and the headset by pressing
briefly. When the link is established,
the online indicator on the base will light up. Consult section 3.1, alternatively 4.7 and 4.8, in the quick
set-up guide for details.
Resetting the base
You may reset the base to remove pairing settings.
To reset the base, complete the following:
1. Open the compartment cover on the bottom of the base and
locate the Reset Hole.
2. Press the Reset button in the hole on the base for 2 seconds with
a pointed object (such as an unfolded paperclip)
.
When the base is reset, the base indicator lights for 2 seconds.
Note:
If you reset the base you will have to pair your headset to the
base again. See the quick guide for pairing instructions. If you do not
re-pair, but put the headset back in the base for charging, the charging indicators will flash slowly to remind
you of the missing pairing.
Resetting the headset
You may reset the headset in two ways.
To reset the headset using your base unit:
1. Place the headset into the base unit.
2. Leave the headset in the Charging Cradle for about
5 seconds, then remove the headset.
3. The headset is now reset and ready for use.
To reset the headset without using your base unit:
1. Press and hold the Volume Down on the Volume button Up/Down.
2. With the Volume Down button pressed, press the Multifunction button at the same time for 5 seconds.
Your headset is now reset and will remain on.
Note:
Your headset will not loose its pairing with neither the base unit nor your mobile phone.
To reset the headset from all its pairings:
1. With the headset switched on, press and hold
for more than 30 seconds.
Note:
You will need to pair your headset with the base again before use with the desk phone. See page 4
in this user guide.
6. Cleaning, safety and maintenance
Clean the headset by wiping with a slightly damp cloth. Dampen the cloth with only water and a little wash-
ing-up liquid if needed. Avoid getting moisture into any button sockets or other openings. The base and
cords may be dry dusted as required.
Do not immerse the GN 6210 in water. The plastic bags the GN 6210 and its parts are wrapped in are not toys
for children. The bags themselves or the many small parts they contain may cause choking if ingested.
GN6210_UG_4.10 04/10/04 14:55 Side 9
