29
english
Jabra GO 6430 User manUal
Headset state
LED when battery level is good
LED when battery level is low
power being turned on
Green 100ms
Off 100ms
repeats to a total of 3 times
same as for good battery level
power being turned off
red 100ms
Off 100ms
repeats to a total of 3 times
same as for good battery level
pairing
Constant blue
Constant red
pairing succeeded
blue 200ms
Off 400ms
repeats to a total of 5 times
red 100ms
Off 300ms
repeats to a total of 5 times
Charging
Constant yellow
Constant red
fully charged in cradle
Constant green
n/a
headset visual signals and their meanings
table 6:
batteRy indicatoRS and RechaRGe
7.6
Battery indicators
the headset indicates the current headset battery level as follows:
- the headset led indicates, among other things, its battery and charging status; see the table above for details.
- While the battery is low, you will hear an audio signal (two quick, low tones) every minute or so in the headset.
Recharging the Headset
to recharge your headset battery, place the headset into its travel Charger and connect the charger to power.
see also
Section 4.1: Charging the headset
.
PoweR Save Mode
7.7
you can choose to put the headset into power save mode. the means that the headset saves power at the
expense of a slightly reduced range.
you can enable / disable power save mode from the Jabra Control Center (it is disabled by default).
If the sound is distorted with power save mode enabled, disable it, then turn the headset off and then back on again.
power save mode uses the bluetooth® wireless technology enhanced data rate (edr) feature.
