4
EN
MFV52116_A
Warning:
The BM-02 does not prevent the occurrence of sleep apnea in an infant! If operated and used in accordance
with this manual, the monitor is unlikely to fail.
INSTALLATION INSTRUCTIONS
1. Place the sensor pad into the crib (pram, Moses basket, etc.) under the mattress (or cushion)
underneath the area where the baby will be sleeping – see the fi gure.
The center of the sensor pad should be approximately where the baby’s chest is.
The pad should be placed on an even fi rm surface
with the printed side facing up – It must not be
bent!
If there is only a bed frame in the crib, place a
fi rm board under the sensor pad; e. g. hardboard,
plywood, etc. The base board should not cover the
whole crib surface so as not to prevent air circulation
– its satisfactory size overhangs the sensor pad by
approx. 3 cm on each side.
For further installation advice and instructions read
page 8, Frequently Asked Questions.
Note:
When using the BM-02 for twins it is absolutely necessary that each baby has its own crib provided with an
independent baby monitor. To ensure correct signal evaluation the cribs must not touch each other.
2. Insert batteries into the device (the battery compartment cover is on the back of the device).
To remove the battery compartment cover, push its straight edge gently and move it towards the round
edge – see Fig no. 1.
Insert batteries.
Only use new alkaline batteries - AA LR6 type (do not use rechargeable batteries].
The polarity of batteries is clearly marked in the battery compartment.
Seal the battery compartment cover and turn the switch to position I.
If the batteries are in good condition, all 3 indicators will fl ash one after another and you will hear a beep.
If there is no beep after turning the unit ON, check the batteries.
Wait approx. 3 seconds before turning the unit on again – after turning the unit on its electronic system
checks the batteries and functions.
The unit must be clearly visible and must not be covered by anything – see Fig no. 2.
If the evaluation unit has to be mounted outside the crib, extend its cable by means of the splitting conne-
ctor and the 5 m long cable (both are included in
the supply).
Fig 1
Fig 1
Book 2016 - 16a.indb 4
Book 2016 - 16a.indb 4
11.4.2017 10:09:01
11.4.2017 10:09:01
Summary of Contents for Nanny BM-02
Page 1: ...baby breathing monitor...
Page 3: ...www jablotron com...
