6
EN
MFV52116_A
ALARM STATUS
If the evaluation unit detects that the baby has not taken a breath for longer than about 20 seconds, the
following type of alarm goes off: fi rstly, there is a short acoustic pre-alarm followed by intensive acous-
tic alarm accompanied with the fl ickering red indicator. If the child is breathing too slowly – less than 8
intakes per minute, the following type of alarm goes off: there is an immediate acoustic alarm and the
red light is fl ickering. Check the baby. If she isn’t breathing, try to wake her up. If she does not wake up,
start administering fi rst aid immediately (release her airways, start mouth-to-mouth resuscitation, etc.).
We recommend contacting a doctor depending on the circumstances. In some cases the alarm signal
itself rouses the baby strongly enough to make her take a breath. To turn the alarm off, press the switch
on the evaluation unit. Exceptionally, a false alarm may occur, which is the case especially when the sensor
pad is not fi tted properly (see the Installation Instructions and the Frequently Asked Questions) or when
the baby can crawl and moves outside the reach of the sensor pad inside the crib.
We hope you hear the alarm signal only once: when testing our product.
SENSOR PAD
A sensor pad can be bought as a separate item. It is available under item No. BM-02D.
It is extremely handy when the device is used in several places; e.g. in another crib, at grandma’s, etc.
In this case the evaluation unit is the only thing you have to remember to take along.
The sensor pad may be placed in incubators by health care providers.
Warning:
Never use another type of sensor pad or those from other manufacturers, nor the BM-02D sensing mat
in combination with another type of product from another manufacturer.
FUNCTION TEST
Check the operation of the device as follows (recommended testing frequency is once a week):
1. When the baby is in the crib and the BM-02 is on, the green indicator must fl icker with the rhythm of the
baby’s breath.
2. Leave the BM-02 on and take the baby out of the crib. The indicator usually keeps fl ickering for a while
until the crib stops shaking. Do not hold on to the crib because the BM-02 could detect your breath and
movements.
3. When the crib has been still for about 20 seconds the evaluation unit gives off a warning beep and then an
alarm signal is activated. While the alarm is on, the red indicator keeps fl ickering. The alarm can be turned
off with the switch.
If the BM-02 does not work check whether:
1. The evaluation unit confi rms the activation of the BM-02 by a low beep and fl ickering. If it does not,
check the batteries.
2. The green indicator stops fl ickering after taking the baby out of the crib. If it does not, the BM-02 detects
disturbing vibrations – see the following information.
Book 2016 - 16a.indb 6
Book 2016 - 16a.indb 6
11.4.2017 10:09:01
11.4.2017 10:09:01
Summary of Contents for Nanny BM-02
Page 1: ...baby breathing monitor...
Page 3: ...www jablotron com...
