jablotron JA-60GSM, User Manual

Page: 9 / 12

User manual JA-60GSM - 9 - MFJ51808
- 9 - MFJ51006
- 9 - MFJ51006
4. General settings
Enter the user mode (see section2.) before using any of the following sequences.
4.1. Remote access code
9 4 xxxxxxxx F1
where:
xxxxxxxx is the code, it can have from 1 to 8 digits
If you enter 94F1 - the code is erased and the remote access to the alarm system is not allowed.
Default setting: 1111
4.2. One-time dialing-in when in user mode
While the control panel is in the user mode, you can enable one-time remote access by entering 970. After
entering this code the dialer responds to the first ring of any incoming call. The access code is not requested,
so the calling phone keypad can be immediately used as the keypad of the alarm system (* = F, # = N).
The immediate dialing-in will be disabled after you dial-in or after you exit the programming mode.
4.3. GSM signal monitoring
The proper function of the GSM dialer is conditional on the GSM signal being strong enough. Enter
971
to measure the GSM signal level. The keypad’s display shows a number from 0 to 9 and it beeps
every second indicating a new measurement. For proper functioning of the module the signal level
should be 3 or higher. Find the best location for the antenna while measuring the signal level.
To switch the system back to the user mode press the N key.
4.4. Attached phone function
The dialer provides a PHONE output to connect an ordinary telephone set. The function of this
telephone can be modified by entering:
98 y
where function
y = 0 ordinary telephone line is simulated, it is possible to
make phone calls (indicated by a dial tone in the
receiver)
y = 1 if you pick up the receiver, the telephone keypad will
work as the keypad of the alarm system. It is impossible
to make phone calls in this mode (you will hear sounds
of the alarm keypad in the receiver)
y = 2 disabled - the telephone has no function
y = 3 emergency call
– if you pick-up the phone, it will dial the
emergency number (see section 4.5)
Notes:

It is possible to switch from mode 0 (ordinary telephone line simulation) to mode 1 (alarm
system keypad) by pressing the “#” key (handset must be picked-up). The phone will return
to mode 0 after being hung-up.

In mode 3 (emergency call) it is possible (within 2 seconds after picking the handset up) to
switch to mode 0 (ordinary telephone line simulation) or mode 1 (alarm system keypad) by
pressing the “ *” or ” #“ key.
4.5. Emergency call number setting
If the attached telephone is programmed for emergency calls (see section 4.4), it will dial the
emergency number after the handset is picked up.