jablotron JA-60GSM, User Manual

Page: 3 / 12

User manual JA-60GSM - 3 - MFJ51808
- 3 - MFJ51006
Notes:

The system confirms an AM command with a reply SMS.

When system arming is impossible e.g. it is in the programming mode, you will be notified about the
situation via a reply SMS.
 If the alarm system is “split” the instruction will effect the section which belongs to the corresponding access
code

If arming without a code is enabled on the control panel, the AM command can be used without any access
code. In this case the command performs the same action as if the keys F 1 are entered on a keypad.
1.6. Disarming via SMS (DM xxxx)
Command DM followed by a valid access code disarms the system. If the system is already
disarmed the command will be ignored.
Send SMS text to the dialer: DM

xxxx
xxxx is a valid alarm system access code (Master or user)

separator (asterisk or space)
Example: Sending of DM

1234 will disarm the system in the same way as if the code 1234 is entered for
disarming on system’s keypad.
Notes:

The system confirms disarming via a reply SMS

When system disarming is impossible
– for example it is in the programming mode, you will be notified
about the situation via a reply SMS.

If the alarm system is “split”, the instruction will effect the section which belongs to the corresponding access
code

If the alarm system is split and the command (AM or DM) is followed by the user code, it will effect the
system the same way as if the code is entered from the alarm system keypad
– no matter if AM or DM is
used (it will arm if the system is disarmed and it will disarm if the system is armed).
1.7. Mode request via SMS (MO)
Command MO can be used to read the current alarm system mode. The dialer will reply with a
reporting SMS to the phone which sent the MO command about status, level of GSM signal, GPRS
status, successfulness of transferring date to the CMSs .
Send SMS text to the dialer: MO
Example: If the system is armed, it will reply to the MO instruction with the SMS: Alarm system
reports: Control panel status: Armed,GSM:7,GPRS OK,MS1 NOT,MS2 OK
Note: if you want to protect this command by a password, set your own command text
– see section 3.3.
1.8. Last event request by SMS (ME)
Instruction ME
is used for reading the last event recorded in the alarm system’s memory. The dialer
will reply with a reporting SMS.
Send SMS text to the dialer: ME
Example: After a fire alarm,
it will reply to the ME instruction with the SMS “ Alarm system reports:
Last event: Alarm end Control panel Time: 02.06. 19:48 “
Note: if you want to protect this command by a password, set your own instruction text
– see 3.3.
1.9. Remote controlling of an appliance via SMS (AUXON, AUXOFF)
These commands can be used for operating the AUX output (e.g. heating in a house). The dialer
confirms the command performance via a reply SMS.
To switch on the AUX output, send SMS text: AUXON
To switch off the AUX output, send SMS text: AUXOFF
To switch on the PgX(Y) output, send SMS text: PGON
To switch off the PgX(Y) output, send SMS text: PGOFF
Example: to switch the heating on send SMS: AUXON
Note: texts of these commands can be customized and protected by a password
– see section 3.3.