![background image](http://html2.mh-extra.com/html/jabiru/j400/j400_owners-manual_3127729042.webp)
Publication
JP OM15
Jabiru J400
Owners Manual
Section: 4
4.3.5.
WARM-UP and FUNCTIONAL CHECK
Warm-up the engine with a fast idle of 1000 - 1200 RPM until the oil temperature
reaches 50 degrees C. During this phase, the cooling of the cylinder head is
insufficient due to reduced airflow across the cylinders. It is therefore advisable not
to shorten the warm-up time by running the engine at higher RPM. The aeroplane
should be pointed into wind to allow additional cooling air. As soon as the oil reaches
50 degrees C, it is possible to do the run-up.
4.3.6.
BEFORE TAKEOFF
1
Brakes
CHECK
2
Cabin Doors
CLOSED & LATCHED
3
Flight Controls
FREE & CORRECT
4
Flight Instruments
SET
5
Fuel Shutoff Valve
ON
6
Elevator Trim
NEUTRAL
7
Flaps
SET FOR TAKEOFF
8
Ignition Check
Throttle to 2000 RPM
Hold this engine speed for 10 seconds.
Switch OFF No. 1 Ignition and watch for
RPM drop.
Switch ON the No. 1 Ignition & switch
OFF the No. 2 Ignition watching for the
RPM drop.
RPM drop should not exceed 100 RPM
on either system.
If drop is excessive, shut down &
determine the reason.
Switch No. 2 Ignition ON.
NOTE
During the check with one system only, the inactive sparkplugs may
tend to load up slightly. To clean plugs, run the engine with both
ignitions for a few seconds, then recheck the second system.
9
Power Check
Throttle to 2850 RPM
Open the throttle fully & slowly to check
REVISION
0
Dated SEPT 00
Page 4-9 of 9