Take the BSR PCB
(Element A)
from the KIT and connect it to the
actuator PCB, by using the connector shown in the picture.
Fix it to the actuator metal plate, by using the Sheet metal
fixing screw
(
Element E).
2
3
1
Remove the screw, which is fixing the
hand wheel.
Remove the 6 screws between the
cover and the body of the actuator.
Carefully lift the cover.
5
4
Place the battery pack
(
Element C)
on the lower battery support
(
Element B)
(Fig.7B).
The battery cables should remain on the bottom part.
Put the cables, as shown in the picture (Fig.7A).
Connect the battery cables to the BSR PCB
(
Element A)
, as per (Fig.7C).
Put the lower battery support
(
Element B).
See (Fig.6A).
Fix it by using 2 Sheet metal fixing screws
(
Element E)
(Fig.6B & 6C).
Place the upper battery support and fix it to the columns of the
lower battery support
(
Element B)
, by using the Plastic fixing
screws
(
Element F)
.
6
8
A
B
C
7
B
C
A
BSR Configuration NO or NC:
NC (normally close) SELDIR jumper ON.
NO (normally open) SELDIR jumper OFF.
Fix the cover to the body by using the 6 screws.
Carefully mount the cover, minding the cables
not to be pressed.
Mount the hand wheel on the shaft and fix
it by using the screw.
15
17
16
9
SELDIR jumper
04
