Put both battery cables
(
Element
C)
together with the plastic clamp
(
Element E)
(Fig. 8D).
Cut the remaining part of the plastic clamp
(
Element E).
BSR Configuration NO or NC:
NC (normally close) SELDIR jumper ON.
NO (normally open) SELDIR jumper OFF.
Fix the 8 screws, between the cover and
the body.
Carefully replace the cover and be sure that
the joint is correctly lodged in its place.
Be sure that any cable is not trapped between
the cover and the body.
Reassemble the hand wheel and fix it with
the screw.
11
12
SELDIR
jumper
10
13
2
3
1
5
Remove the hand wheel screw and
take it off.
Remove the 8 screws between the
cover and the body of the actuator.
Carefully remove the cover, in order to
install the kit.
Take the BSR PCB
(Element B)
from the KIT and connect it to
the actuator PCB, by using the connector shown in the picture.
Fix it to the actuator metal plate, by using the Sheet metal
fixing screw
(Element D).
4
Fix the battery supports
(
Element B)
, with the sheet metal
fixing screws
(
Element D)
. Connect the battery cables to the
BSR PCB
(
Element A)
, as per
(
Element C)
.
8
6
9
A
A
B
B
Place the 2 battery packs
(Element C)
as per picture (Fig. A & B).
Place the 2 battery supports
(Element B)
as per picture (Fig. A & B).
7
A
C1
C2
Connect 1
Connect 2
Place the battery cables so as they remain over
the battery pack (fig. 7A).
Connect the C1 battery cable to
connect 1.
Connect the C2 battery cable to
connect 2.
10
