3 |
P a g e
J Tech Photonics, Inc.
Pic-
Convert™ Board Instructions V2
.7
Copyright 6/13/17
Power Overview
The board requires >+6v. We have provided a 7V wall style power adapter with the board. We
recommend using this adapter as it provides a clean isolated power source.
You can also use a power supply that is larger (up to 24volts), but make sure the regulator does not get
too hot. The regulator is the IC right next to the barrel power connector. If needed for higher voltage
operation, a heatsink can be added via the screw hole on the package.
There are three ways to power the Pic-
Convert™
board:
1.
Barrel type connector power supply. Either use the enclosed plug to wire connector provided
2.
Screw Terminals connections.
3.
Solder points for wire connection.
Jumper Settings
The jumpers come pre-set at the factory for PWM and Relay Enabled.
