Fig.10
Use the configuration you need by moving the DIPs:
In order to set the actuator up, use the DIPs shown in picture .
To make the KITS assembly, follow the steps on the instruction manual enclosed inside each kit.
7. DPS
8. KITS BSR / KIT DPS
*VERY IMPORTANT:
BEFORE CONNECTING “A” PLUG TO THE ACTUATOR, CHECK THAT THE
VOLTAGE IS THE SAME AS THE ONE SPECIFIED ON THE ID LABEL (CARTER).
B. plug - Connect a cable between PIN 1 (on the right side) and PIN Earth (on the bottom)
(Fig. 11).
A. plug - Connect voltage to the actuator in the following way:
VAC: PIN1 (neutral) and PIN2 (phase).
VDC: PIN1 (negative) and PIN2 (positive).
B. plug - Disconnect the cable between PIN 1 (on the left side) and PIN Earth (on the bottom).
The actuator will make a complete maneuver.
The actuator is ready to connect the (4/20mA or 0/10V) signal to the B plug
Fig.11
J4C 20 to 85 COVER
J4C 140 to 300 COVER
A
C
B
A
C
B
External adjustment
06
INDEX
ENGLISH
- J4C 20 TO 300 INSTALLATION INSTRUCTIONS
