J.E. Adams 8670-5WB, Manual, Page: 13 / 22

8670-5WB Manual – 10/2006 13
Figure 7: Infitec timer setup
Figure 7 shows an Infitec timer set for 2 coins to start and a total run time of
240 seconds (4 minutes).
TIMER SETUP – INFITEC TIMERS
The Infitec timer has two adjustable settings: Total run time (in seconds)
and number of coins to start.
Total run time:
Total run time
is the amount of time the unit will run once activated and
can be set from 1 second to 1023 seconds (17 minutes and 3 seconds) in
increments of 1 second by turning on the correct switches until their
values equal the desired time
. Refer to Tables 1 and 2 (pages 14-15) for
standard timer and coin settings. For custom settings, follow the steps
below:
1. Figure the total time your vac will run (in seconds). This is your
total run time . Round up or down as desired.
2. Subtract the largest value switch (initially 512) from your total run
time .
a. If the resulting number is zero , move the switch to the “on”
position and set all remaining un-set switches in the “off”
position. Your timer is now set.
b. If the resulting number is positive , move the switch into the
“on” position. Using the resulting number as your new time
per coin , repeat step 2 with the next largest switch value.
c. If the resulting number is negative , set the switch in the
“off” position and repeat step 2 using the next largest switch
value.
Coins to start:
Coins to start is the amount of coins needed to activate the timer and
can be set from one to 15 coins in increments of one coin. Refer to Table
1 (page 14) for switch settings.