J.E. Adams 8670-5WB, Manual, Page: 11 / 22

8670-5WB Manual – 10/2006 11
Figure 5: SSAC timer setup
Figure 5 shows an SSAC timer set for 1 coin to start and 3.8 minutes per
coin for a total run time of 3.8 minutes (3 minutes and 48 seconds).
TIMER SETUP – SSAC TIMERS
Note: “AE” and “AN” model SSAC timers are accumulating timers.
During use, timing can be extended proportionately by adding more
coins.
The SSAC timer has two adjustable settings: Time per coin (in minutes)
and number of coins to start.
Time per coin:
Time per coin
is the amount of time the unit will run per coin inserted
and can be set from 0.1 minutes (6 seconds) to 12.7 minutes (12 minutes
and 42 seconds) in increments of 6 seconds by turning on the correct
switches until their values equal the desired time . Refer to Tables 1 and 2
(pages 14-15) for standard timer and coin settings. For custom settings,
follow the steps below:
1. Figure the total time your vac will run (in minutes) and divide that
number by the number of
coins to start . This is your time per coin .
Round up or down to the nearest tenth of a minute.
2. Subtract the largest value switch (initially 6.4) from your time per
coin .
a.
If the resulting number is zero , move the switch to the “on”
position and set all remaining un-set switches in the “off”
position. Your timer is now set.
b. If the resulting number is positive , move the switch into the
“on” position. Using the resulting number as your new time
per coin , repeat step 2 with the next largest switch value.
c. If the resulting number is negative , set the switch in the
“off” position and repeat step 2 using the next largest switch
value.
Coins to start:
Coins to start is the amount of coins needed to activate the timer and can
be set from one to seven coins in increments of one coin. Refer to Table
1 (page 14) for switch settings.