J.C. SCHWARZ JWS 2400PA, Manual

Page: 105 / 108

EN 105
INSTALL WHEEL
THICKNESS: < 4 MM
Install straight grinding wheels with the
lock nut 10 so that the flange points away
from the machine.
Press and hold the spindle lock button 7
and tighten the lock nut 10 with the
wrench.
1
Remove the grinding guard 5 , by pulling it
straight upwards.
Make sure that the locating slots on both
the machine and the guard are properly
aligned before pulling.
2
The tool will then be in lock on position. To
switch off the tool, press and release the
on / off switch 3 .
CHANGE GUARD
Remove the grinding wheel, press the
guard lock lever 8 and rotate the grinding
guard 5 into the position shown.
1
ADJUST GUARD
Press the guard lock lever 8 and keep it
pressed.
1
ON / OFF SWITCH
To switch on the tool, push the small le-
ver forward and then press the on / off
switch 3 .
1
Rotate the grinding guard 5 clockwise
into the desired position. Make sure that
the guard lock lever 8 is engaged in the
grinding guard 5 .
2
THICKNESS: ≥ 4 MM
Install depressed grinding wheels with
the lock nut 10 so that the flange points
towards the machine.
Press and hold the spindle lock button 7
and tighten the lock nut 10 with the
wrench.
2
Press the guard lock lever 8 and keep it
pressed. Rotate the cutting guard clock-
wise into the desired position. Make sure
that the guard lock lever 8 is engaged in
the cutting guard.
4
Install the cutting guard (accessory) by
pushing it on the machine in the position
shown.
Make sure that the locating slots on both
the machine and the guard are properly
aligned before pushing.
3
Warning! Make sure the tool is
switched off and unplugged.
Warning! Make sure the tool is
switched off and unplugged.
Warning! The guard shall be oriented
to protect the auxiliary handle.