J. A. Roby ULTIMATE TOR 2015, Instruction Manual

Page: 23 / 33

PR_I020/2023-08-11-EN
Revision: 5
23
Operating Instructions
➢
OPERATE ONLY WHEN DOOR IS CLOSED: Keeping the
door open might over fire and cause permanent
damage to the stove or a chimney fire.
➢ IT’S RECOMMENDED TO INSTALL A CO, CO2 AND
SMOKE DETECTOR INTO THE SAME ROOM THAN THE
STOVE. The smoke detector might go on when there is
smoke leaking out.
➢
NEVER SLAP THE DOOR.
➢
NEVER BURN INFLAMMABLE LIQUID: Inflammable
liquid makes very intense heat and it is hard to control
the combustion. It might cause the runaway and
overheat of stove. This can consequently make
permanent damage to the stove or a chimney fire.
➢
ALWAYS VERIFY IF THE AIR INLET IS NOT
OBTRUCTED BEFORE LIGHTNING A FIRE.
➢
NEVER ELEVATE FIRE WITH GRATE OR ANDIRON.
ALWAYS MAKE FIRE DIRECTLY IN THE HEARTH.
Removable Handle Installation
Slide the square metal rod inside the square and rectangular
orifices of the removable handle. Remove the handle after
adjusting the air intake so that it doesn’t get too hot. Leaving
the handle in place and touching it while the stove is in function
might cause burns
Primary and secondary air admission
control
When the handle on the side of the stove is vertical, the air
admission comes only from the tubes, this is what we call
“Secondary air admission”. When the handle is angled, the air
admission is direct and from the air intake above the door
which is called “Primary air Admission”.
Warning: Operating the stove with the Primary air
admission fully open for a long period of time can damage
the stove.
IT IS PROHIBITED TO MODIFY AIR ADMISSION TO
OBTAIN A HIGH HEAT OR ANY OTHER REASONS. ANY
MODIFICATION CAN AVOID GUARANTEE.
Lightning fire
After installing correctly the stove following the installation
instruction of the manufacturer, you are ready to light it.
1) Turn the admission handle in horizontal position to set
the primary air admission.
2) Put paper and lightning wood in the combustion
chamber and light the fire in your way.
3) Close partially the door keeping a slight opening. When
chimney have enough heat buildup, close the door
completely and lock it. Wait for a good fire buildup.
4)
Once you have an ember fire, it’s time to add logs.
Follow now the instruction section on how to keep a
fire.
5)
Once you have an ember fire, it’s time to add logs.
Follow now the instruction section on how to keep a
fire.
DO NOT OVER CHARGE THE STOVE MORE THAN THE
UPPER BRICK ROW.
You can control the combustion by turning up or down the
handle. The wood will burn more rapidly when more primary air
is set. Otherwise, the wood burn more slowly and more
efficiently with the handle set to secondary air.
•
NEVER LEAVE THE STOVE UNATTENDED WHEN
THE DOOR IS SLIGHTLY OPEN. ALWAYS CLOSE
THE DOOR AFTER LIGHTNING.
•
ALWAYS USE THE STOVE WITH THE DOOR
CLOSED.
•
DO NOT USE ANY CHEMICAL PRODUCT OR
INFLAMMABLE LIQUID TO LIGHT OR REKINDLE THE
FIRE.
•
DO NOT BURN WASTE OR ANY OTHER
INFLAMMABLE PRODUCTS AS GASOLINE,
NAPHTHA OR MOTOR OIL.
•
DO NOT MAKE FIRE TOO CLOSE TO THE GLASS.
•
KEEP INFLAMMABLE PRODUCTS FAR FROM THE
APPLIANCE.
First fire
The first hours of operation, you must heat it gradually. In order
to allow an appropriate baking of the paint and in order to
facilitate its adhesion with metal, do not heat the appliance with
a strong fire. It will also avoid thermal shock which could lift up
the paint or make the color fade.
Make sure that the room is ventilated enough in order to
eliminate the odours and the smoke coming from the paint
during the first hours of usage.