izzy NDS-24C, Instruction Manual

Page: 11 / 18

10
EN
Safety Interlocks
Read carefully and save the instructions for use provided with the
appliance and keep them for future reference.
• Use the appliance only for the intended use as indicated in this instructions
manual.
• Before connecting the appliance on the supply mains, check that the
voltage indicated on the data plate of the appliance corresponds to that of the
voltage mains in your home. If this is not the case, do not use the appliance
and contact one of the authorized BENRUBI Service Centres.
• Always connect your appliance by means of an earthed plug. Non-
compliance with this obligation can cause an electric shock and may lead to
serious injury. It is vital for your own safety that the earthed socket
corresponds to the electrical installation standards in force in your country. If
your household electrical system does not include an earthed socket, it is
vital that you call in an authorized technician before plugging in the
appliance, in order to bring your electrical system up to standard.
• Any fault in the connection, cancels the warranty.
• Any repairs made from a non authorized Benrubi Serivce center, cancel the
warranty.
• Do not use the appliance in the bathroom, near a swimming pool or in any
place where it may get wet.
• Do not place the appliance in places where it may come into contact with
water.
• Do not leave the appliance unattended during use.
• When switching on the appliance for the first time, allow it to run at full
power for about two hours to get rid of the unpleasant smell. Make sure that
the room in which the appliance is located is well ventilated during this
operation. It is normal for the appliance to emit small cracking sounds when
you turn it on during the first use.
• To reduce hazard of injury due to electric shock, always follow the
safeguards as stated below:
• To protect against the risk of electric shock, do not immerse the appliance in
water or any other liquid. The heater should never be used under conditions
where it may be immersed, or come in contact with water. Similarly do not
plug in your heater if its surfaces are wet or damp.