Installation
Tastic
®
NOTE:
This product must be installed by a qualified
installer. Ensure power is off to location of Tastic
1. After determining the location of the Tastic, use the
card included with your Tastic Carton as a template
to mark out and cut an aperture in the ceiling.
Make sure that template is parallel to a wall
2. Remove fascia from the body. Remove all lamps,
rubber band and switches from motor mounting
channel. Spin fan to check freedom of rotation.
3. Unscrew terminal cover and make necessary
wiring connections. Refit terminal cover. Do not
turn on power to Tastic.
4. Push Tastic body into ceiling aperture, allowing
metal springs to snap open. As the Tastic is raised
into the ceiling, ensure electric cables do not rest
over the Tastic.
5. To secure the Tastic in position, push lower ends
of springs apart (Fig 10). Ceiling board thickness
should be adjusted to enable springs to be fitted
without excessive force.
Final Assembly
1. Model 11341, fit fascia into position and hook
coil-spring onto fascia as per Fig. 11. Models
12341 and 12343 have snap fit fascia, however
the lamps and centre globe must be fitted in
these models prior to the fascia. The legs of the
lamp surround must rest freely on the ceiling.
A clearance of approximately 3-5 mm should exist
between the ceiling and outer rim of surround.
2. Insert infra-red lamps and centre globe into socket
and screw in well to give good electrical contact
to ensure correct operation.
3. Centralise fascia and wipe surround and
bulbs clean.
4. Turn on power and check operation of Tastic.
Fig. 9: Use template to mark position of Tastic
Fig. 10
Fig. 11 – 11341
Summary of Contents for Eco Tastic 12343
Page 19: ...Notes Tastic...
