IWILL KK400 Series, User Manual

Page: 80 / 110

KK400 Series Motherboar KK400 Series Motherboar
KK400 Series Motherboar KK400 Series Motherboar
KK400 Series Motherboard d
d d
d
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
U U
U U User’
ser’
ser’ ser’ ser’s Manual
s Manual
s Manual s Manual s Manual 5•18 5•18 5•18 5•18 5•18
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
If you install an IR port module, you have to set the UART
Mode Select line to the appropriate IR setting. Check the
module instructions for this information. The following
four lines will display the defaults for the IR mode you
select and should work.
You can alter the parallel port settings as needed. You can
disable the Game and MIDI settings if you aren’t going to
use the Game port header.
The last several items when at the bottom of the main
Integrated Peripherals screen are SCR Port Address and
MS/SD Port Address. These enable and configure a
Smartcard reader and Memory Stick™ and Secure Digi-
tal™ memory card reader respectively. Either of the listed
port addresses should work. You must set MS/SD Port
Address to use the optional FI Panel.
CMOS Setup Utility – Integr CMOS Setup Utility – Integr CMOS Setup Utility – Integr CMOS Setup Utility – Integr CMOS Setup Utility – Integrated P ated P ated P ated P ated Peripher eripher eripher eripher eripherals - Super IO section als - Super IO section als - Super IO section als - Super IO section als - Super IO section