EN
EN
3.
Operation
3-1 Control panel
5
10
15
0
20
25
30 35 40
45
50
55
60
65
Start
Stop
Speed Setting (cm/min)
I N D U S T R I A L
R
7
4
1
6
5
2
3
1
Power Switch:
Indicating light is on after electrify.
2
Start Button:
Welding Carriage start to travel after pressing down this button, while whether
to begin the welding operation is determined by the mode switch.
3
Stop Button:
Welding Carriage stop traveling after pressing down this button, while wheth-
er to end the welding operation is determined by the mode switch.
4
Traveling Direction Switch:
This switch is change the traveling direction.
5
Traveling Speed Control Knob:
Increase the traveling speed by turning the knob in clock-
wise, conversely the reverse
6
Main Fuse:
3A
7
Welding Mode Selector Switch:
There are three modes can be chosen.
Manual Arc Extinguishing:
If selected, wire feeder in operation, it can be arcing / arc
extinguishing manually, and it auto reset after releasing hand.
Auto Arc Extinguishing
: If selected, it will be the normal welding operation.
After pressing down the start button, carriage starts to travel and arcing at the same time.
Auto arc extinguishing procedure is involved once the welding operation is finished. In this
case, the end of beam will be plump.
Non Weld:
If selected, after pressing down this button, carriage will traveling and not
doing the welding operation.
56
