EN
EN
2.
Installation
1
2
3
0
4
5
6
7
8
9
10
11
12
13
14
280
26
0
265
2
4
3
1
5
6
7
8
9
10
1 - Drive Part: It is a system to drive the welding carriage and it consists of four rubber wheels,
bevel wheels, chains and chain pulley.
2 - Vertical - Horizontal move regulating unit: Arcing start point can be adjusted by 43 mm along
the Up/Down, Forward/Backward direction.
3 - Socket: It is for external cable, it used as the connection with wire feeder and the power sup-
ply. (This cable has two branches at the opposite end, one is connected to wire feeder and
the other is connected to power supply)
4 - Operation Panel: See section 3-1.
5 - Torch Clamp Assembly: Make sure the welding torch is fasten tightly during installation.
(Clamp to the insulation parts)
6 - Left/Right Guide Wheels: The guide wheels should closely cling to the backup plate and they
are able to be set in three different positions:
2-2. Overall Schematic Diagram
2-1. APPLICABLE WORKING CONDITION AND ENVIRONMENT
1. Transport and store condition:
1) Ambient temperature range:-25°- +55°
2) Relative humidity: Less than 40° ≤50% , At 20° ≤90%
3) In areas, the contents of dust, acidic, corrosive gas or corrosive substance is less than standard
4) In areas, not exposed to rain
2. Working condition:
1) Altitude ≤ 1000 meters.
2) Ambient installation and working temperature: -10°- 40°
3) Humidity: ≤90% ±25%
4) In areas, free from corrosive gas, moisture content, steam, chemical precipitate, dust, mildew
or other explosive, corrosive substance.
5) In areas, no serious shake
54
