EN
Attention! If the filter can not be darkening or the darkening shade is not enough or
the: darkening speed is slow or the filter is flash, for such abnormal work, please find
the reason immediately. If operator can not solve the problem, please must stop
using the helmet immediately and contact with the dealer in time!
1)
Delay time button: Delay time can be adjusted, time of filter from dark state
to light state, avoid the damage to eyes from the residual arc of welding molten pool
due to too fast switching time to light state when welding is end (Break arc). The delay
time is 0.1s-1.2s The switching time may vary due to different welding types and differ
-
ent sensitivity setting even delay time handle is at the same position.
If the filter is flash under low current welding, please adjust the delay time handle to
long position, this can help to solve this problem.
4.4 Delay time
Arc Gouging
MIG Sheet Metal
MIG Plate welding
Attention!
Before welding, please keep clean on filter, front cover lens, inside cover lens and
four optical sensors. If front cover lens and inside cover lens are blurry and can not be
clean, please replace them immediately.
When grinding, the helmet shell can not bear the welding spatter which is more than
43 grams and exceeding 120m/sec. The helmet meet standard DIN EN 175:1997 (B
impact Level). For other body parts helmet can not protect, please wear other safety
products for protection!
7
6
Summary of Contents for FLIP-UP DIGITAL 5.2
Page 16: ......
Page 24: ...www iweld hu...
