iWeld 800MIG350IGBT, Manual

Page: 42 / 52

2-3 Connect the wire feeder
1. The long axis of the wire feeder lock the wire roller that specific wire. Make sure that the
wire roller is suitable for the wire used!
2. Wire should roll down clock wise, then cut the line, off-stage, it is only after pinning it on!
3. Tighten the hold-down screws on the wire, put the wire into the wire feed guide wheel and
thread the wire to the welding torch.
4. Press the button on the wire feeder to the welding torch into the wire.
2. Installation
2-1. Connection of the power wires
1. Each machine is equipped with primary powerwire, according tothe input voltage, please
connect the primary wire to the suitable voltage class.
2. The primary wire should be connected to the corresponding socket to avoid oxidization.
3. Use multimeter to see whetherthe voltage value varies in the given range.
2-2. Connection of output wires
1. Connect the welder’s terminal plug(-) to the work piece by work lead
2. Connect the welder’s terminal plug(+) to the wire feeder by welding cable
3. Connect the welder’s control cable socket to the wire feeder by control cable.
4. Connect feeder’s gas hose to the regulator
5. Connect the regulator’s heater cable to the welder’s “gas heater power ”cable socket.
(on the rear panel)
6. Connect the welder’s power cable to the disconnection switchboard, while grounds the
lead safely.
7. Reset the circuit breaker on the welder’s rear panel.
power supply
(AC 380V-420V)
Control
box
Input cable
Gas tables
Gas cylinder
Gas
pipeline
Wire feeder
Welding
torch
Workpiece
Heating
Electric
welding
machine
Positive output
Control cable Negative outputs
EN-6