HU
EN
5
2. SAFETY
DEVICES
This system comes equipped with the following safety devices:
Circuit braker:
- To avoid overloading during cutting.
Pneumatic protection:
- Pressure control, located at the inlet of the torch to prevent low air pressure.
Electronic protections :
- If the main voltage is too low or too high.
- Torch maintenance on.
- In this case, all cutting functions are inhibited.
2.1
SAFETY DEVICES SIGNAL
DYNA
CUT 130 PILOT
Green Led ON/OFF
Alarm when torch
nozzle is loose
Allarm when over load,
over current, supply
voltage outside limits
3.
START-UP AND USE
The machine must be installed by quali
fi
ed personnel. All connections must
be made in compliance with current safety standards and full observance of
safety regulations.
