- 5 -
1. Unpacking & Inspection
On unpacking the product, check the following
points. If you find any problems, contact your
nearest dealer.
1. Check the information on nameplate and con-
firm the product is delivered as per order.
2. Check for transit damage, deformation, and
loose bolts.
Tighten the rear casing support mounting bolts
to the specified tightening torque. See "13.
Disassembling & Assembling" section for the
specified tightening torque.
3. Check if accessories are included.
Bolt for back pull-out:
M12×100mm (2pcs)
Optional accessories (if ordered):
Spare parts and the dry run protector, etc.
Pump unit (Liquid feeding section)
Not capable of self-priming:
Before operating the pump, feed liquid
through the suction or discharge port.
Drain port
Drain a liquid into a suitable container.
Follow an applicable local regulation
at disposal of liquid. Never allow the
discharged liquid to flow directly onto
the ground.
Motor nameplate
Use only the power
voltage specified on the
nameplate. Follow an
applicable local power
regulation.
Suction port
Base plate
Discharge port
Foot support
Nameplate
Eye bolt
CAUTION
When cleaning the pump, do not wipe the nameplates, labels or the pump body with
any solvent.
Outline
