IVT Rego 5101, Installation Manual

Page: 14 / 40

Settings
6 720 645 172 (2010/07) en
14
4.4 Settings\Additional heat
The tables display the settings for different types of
additional heat:
•
Internal add. heat E2 (3 step)
•
District heating E51
•
Modulated add. heat E71
•
Mixed add. heat E71
B
Read more about additional heat (
Æ
Chapter 4.4.1 -
4.4.7).
Setting Factory Range HP
Additional heat
Additional heat type No additional heat
Comp. + add. heat
No additional heat
Internal add. heat
District heating
Modulated add. heat
Mixed add. heat
Only additional heat
Comp. + add. heat
Only compressor
E21
B
Set applicable Additional heat type and desired additional heat operation. In Internal add.
heat is shown:
Settings Start E2.E1
Hysteresis
Delay
Actual v.
:
3 K
180 °min
Display, can be changed
E21
Start E2.E2
Delay
Actual v.
:
60°min
Display, can be changed
Start E2.E3
Delay
Actual v.
:
60°min
Display, can be changed
Stop E2.E1
Delay
Actual v.
:
10°min
Display, can be changed
Stop E2.E2
Delay
Actual v.
:
5°min
Display, can be changed
Stop E2.E3
Delay
Actual v.
:
5°min
Display, can be changed
Settings
Max no. of steps in
:
Heating :
Hot water :
2
2 0, 1, 2, 3
0, 1, 2, 3
B
Set conditions for when respective stages must connect/disconnect.
B
Set how many steps may be used as a maximum for heating mode and hot water mode.
ECO-drive ECO-drive
Start
Stop after No
22:00
6 hr
No , Yes
00:00 - 23:59
E21
B
Indicate Yes if activation of the additional heat is to be delayed during a set time period.
The delay increases by 25% for the first stage.
Tab. 33 Internal electric additional heat