OPERATING INSTRUCTIONS
Work lamp PL-810
Part.- no. 320004
Intended use
This work lamp is used to illuminate working areas at work or at home. The work lamp can be mounted both indoors as well as in
protected outdoor areas. Common 230 V AC consumers of up to 2700 W/12 A can be connected to the 230 V AC socket.
Any other use than the one described above will damage this product. It also includes hazards, such as short-circuit, fire, electric shocks
etc. The entire product must not be modified or converted in any manner whatsoever!
Prior to putting the product into service, please read the complete operating instructions thoroughly. They contain important information
regarding the proper operation of the product. It is absolutely necessary to follow the safety instructions!
Safety instructions
The warranty for this product shall be void in the event of damages caused by non-compliance with the operating instructions!
We assume no liability for any consequential damages!
We assume no liability in the event of personal injury or property damage caused by the improper operation and handling of
the product or by the failure to observe the safety information! Any warranty claim shall be void under those circumstances.
•
For safety and technical approval reasons (CE), the unauthorised conversion and/or modification of the device is not
permitted.
•
The work lamp must not be exposed to extreme temperatures, strong vibrations or heavy mechanical stresses. These
circumstances may cause the damage of the lamp.
•
If you observe any damage, do not use the product any longer.
•
The product is not a toy and must be kept out of the reach of children. There is a risk for a fatal electric shock.
•
Install and use the product where it is out of the reach of children.
•
Do not leave packing materials unattended. Plastic films/bags, polystyrene parts, etc. may become dangerous toys for
children.
•
The work lamp may only be operated with a 230 V AC/50 Hz power source. Never try to operate the device on any other
voltage!
•
Only consumers of up to 2700 W/12 A may be connected to 230 V AC socket of the lamp.
•
The work lamp may only be operated indoors or in protected outdoor areas.
•
Do not use the lamp in rooms or under adverse environmental conditions where flammable gases, vapours or dust are
present or might be present!
•
The work lamp must not be put up in areas that are prone to flooding or in areas, e.g. hollows, where rainwater might gather.
•
Do not cover the product while it is in operation. Danger of fire!
•
If there is reason to believe that safe operation is no longer possible, the device must be switched off immediately and
secured against unintentional operation.
•
There is reason to believe that safe operation is no longer possible, if:
-
the lamp has visible damages
-
the lamp does not work
-
after the lamp has been stored under adverse conditions
-
following severe transportation stress
•
Any maintenance or repair work may only be performed by an authorised repair shop.
Mounting
The lamp must be voltage-free during installation. Turn the power off (remove the electric circuit fuse) and protect it from unauthorised
re-start! Check that the mains connection is free of current.
Possible applications
1.
The work lamp may be used as stand lamp, as wall-mounted lamp or as hanging lamp
2.
Up to ten work lamps can be connected in series.
Summary of Contents for PL-810
Page 9: ......
