10
Instruction manual
EN
plunge the saw blade slowly into the workpiece.
∙
After reaching the required cutting depth, bring the
machine again to the normal working position so that
the complete surface of the base plate rests on the
workpiece and continue to saw along the cutting line.
[F4]
∙
After completing the cut, first switch «off» the
machine an then pull it out of the cut.
Circle cutting (circle cutting guide is not included)
[F5]
∙
Mark the circle which will be cut and drill the
opening in its centre.
∙
If the cutting does not start from the edge of the
material, drill the opening from which the cutting will start.
∙
Mount the circular guide on the machine.
∙
Slide the circular guide in order to determine the
radius of cutting and lock it using the locking screws.
∙
Place the aligning pin in the central opening and
start the cutting by moving the device over the circle.
In order to get the optimal results it is recommended
to use the narrow blades.
STROKE RATE SELECTION
With the thumbwheel (10), the required stroke rate can
be selected (also while running).
[F6]
PENDULUM ACTION SETTING
The saw blade pendulum action that is adjustable in four
steps, makes possible the optimal adaptation of sawing
advancing (cutting speed), cutting performance and cut
appearance of the machined material.
For each downward movement, the saw blade is lifted
off the material, which facilitates sawdust ejection,
reduces heat generated by friction and increases the
service life of the saw blade. At the same time, the
reduction of the necessary advancing force provides
fatigue-free working.
The lever for pendulum stroke adjustment (9) makes
possible the adjustment of the pendulum action in four
steps. The switching can take place with the machine
running.
[F7]
0
: No pendulum action
1
: Small pendulum action
2
: Medium pendulum action
3
: Large pendulum action
The following basic recommendations are to be
observed:
∙
The smaller the pendulum step selected (or
switched OFF), the finer and cleaner the cut edge;
∙
When working with thin materials, like metal sheet,
the pendulum action should be switched OFF;
∙
Materials such as soft wood cut in the direction of
the grain, should be cut with the maximum pendulum
action setting.
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙
Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙
Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
