6
e
55
40
25
n
13
p
q
o
9
10
j
h
11
i
g
12
25
75
7
Manual instruction |
Electric Lawn Mower
EN
apertures for the handle (5) on the motor housing
(14) and lock into the position with the handle self-
tapping screw (c).
Attach the upper part of the handle (3) to the
•
lower part (2) using the ferrule nut (f) and the knobs
(4), handle bolts (d) and curve washer.
Attach the cable clips (8) and the cable hook (7)
•
to the upper part of the handle (3).
Mounting the switch box (6) and connecting the
mains
Fix
the
•
switch box (6)
to the upper part of
the handle (3) using
the supplied switch
box screws (e).
S e c u r e
•
the
appliance
connection line with
the cable clips (8).
Plug
the
•
appliance connection line into the switch box (6) and
secure it with the cable hook (7), which eliminates
any tension thereon.
The loop of the mains wire
must be long enough for the
cable hook (7) to be able to
slide from one side to the
other. Ensure that the cable is
sufficiently slack.
Mounting the grass catcher (9)
(ELM-900; ELM-1400)
Put both parts of the grass catcher (9) together, so
•
that they could wedge in each other and block
them with the grass catcher
clamps (n) (if present).
Lift up the deflector (10)
•
and, whilst holding it in this
position, insert grass catcher
(9). The plastic clips should
engage.
(ELM-1700)
Put the nylon bag (13) of the grass catcher (9)
•
onto the metal frame (p), let the leather surface (o)
at the underside.
Unclench
each
•
leather side using a
tool (for example, a
screwdriver), make
them to wrap the
four metal wires on
the metal frame (p).
Snap plastic
•
latches (q).
Open the
•
deflector (10)
and, while keeping
it, place the grass
catcher (9) at that,
the rods of the
metal frame (p) must fit completely into the plastic
hooks of the case.
Setting the cutting height
Caution! Make the adjustment of cutting
height only with the motor switched off
and the blade shaft at a standstill!
(ELM-900; ELM-1400)
Your machine enables the following cutting height
settings: 24mm, 40mm, 55mm.
The cutting height is adjusted directly at the four
wheels (11). Three different cutting height settings
are available for each individual wheel (11).
All wheels (11) should be adjusted on the same
position for mowing.
To adjust the cutting height:
Unscrew the wheel hubs (h) by turning anti-
•
clockwise and pull off together with wheels (11).
Position the wheel hubs (h) and wheels (11) into
•
one of the holes for
selecting the cutting
height (j) and choose
the desired height.
Ensure that all
•
sprockets
(i)
are
placed at the same
height.
(ELM-1700)
Your machine enables eight cutting height settings:
from 25mm to 75mm.
The cutting height is adjusted by a central height
adjustment lever (12)
on the machine.
To adjust the cutting
height:
hold the adjustment
•
lever (12) and pull
the lower part of the
adjustment lever
