General Installation Guide
This
ED2-AT Series SkidWeigh
system installation & calibration guide describes how to install, calibrate, test and use
your on-board check weighing unit. Following the instructions in this guide will enable you to get your system operating
quickly and easily. In the event that you require additional assistance, please contact customer support via e-mail at
or contact us at the address or contact number below:
Integrated Visual Data Technology Inc.
3439 Whilabout Terrace, Oakville, ON, Canada, L6L 0A7
Phone: 905-469-0985, Fax: 905-825-9494
Safety
Always disconnect the vehicle battery while installing SkidWeigh system or any other electronic product.
Make sure sure that unit, pressure transducer and any other associated cables are securely mounted and do not impede
any of the vehicle’s controls. Use care when routing the components cables. Route the cables where they will be
protected. Use commonly accepted install practices for after market industrial vehicle electronic devices.
The installation of the SkidWeigh systems should only be performed by an acknowledged lift truck dealer technician or
end user electro and hydraulic technical installer.
Here are two acceptable methods of making a wire connections:
* Soldering your connections (recommended)
* Crimp connectors ( with the use of the proper crimping tool)
Regardless of the method you choose, ensure that the connection is mechanically sound and properly insulated. Use
high quality electrical tape and shrink tubing where necessary.
This product is connected directly to the vehicle’s ignition switch, 12 to 55 V DC. There is no on-off switch on the unit.
Electro-Magnetic Compatibility
CE conformity to EC directive 89/336 (EMC) by application of harmonized standards: Interference stability EN 61000-6-2
and EN 61326-1 interference emit EN 61000-6-3, EN 61326-1 for the pressure transducer.
ED2 SkidWeigh Series
Our policy is one of continuous improvement and the information in this document is subject to change without notice.
Check that software version displayed on LED is the one applicable for your application.
Overview of components
The standard
ED2-AT SkidWeigh
check weighing system consist of two main components:
* Digital indicator with wiring harness, mounting bracket and anti-vibration mount
* Hydraulic pressure transducer with 3 wires cable
* Installation & Calibration manual and operator usage instruction
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
