background image

cautions:

1) Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or just after cooking. Do not touch with 
bare hands.
2) Keep the stainless steel probe sensors and wires away from children.
3) Clean the stainless steel probes and dry thoroughly after each and every use.
4) Do not use the receiver in the rain. It is NOT rain proof. The transmitter is rain proof but not water tight. Do not immerse in water.
5) Do not expose the plugs of the stainless steel probes or the plug in holes of the transmitter to water or any liquid. This will result in a 
bad connecting and faulty readings.
6) Do not expose the receiver or transmitter to direct heat or surface.
7) Do not use stainless steel probes in microwave oven.
8) The Barbecue Thermometer registers temperatures as low as 32˚ F (0˚ C) and as high as 572˚ F (300˚ C). LLL will be displayed below 
32˚ F and HHH will be displayed above 572˚ F. Do not use the stainless probe sensor above 572˚ F. Doing so will deteriorate the wire.
9) Not Intended for Use by Persons ages 12 and Under.

cleaning

1) Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or just after cooking. Do not touch with 
bare hands.
2) Keep the stainless steel probe sensors and wires away from children.
3) Wash the metal probe tips with hot soapy water and dry thoroughly. Do not immerse the probe in water while cleaning.
4) Wipe the transmitter and receiver with damp cloth. Do not immerse either in water.

information to user

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users’ 
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause 
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

LIMITED ONE YEAR WARRANTY

C&A Marketing, Inc. warrants the Ivation Wireless BBQ Thermometer to be free of defects in parts, materials and workmanship for a 
period of one year from date of purchase. Should any repairs or servicing under this warranty be required, Contact C&A Marketing Inc. 
and ship the Ivation Wireless BBQ Thermometer to the C&A Marketing Inc. service center located as follows:
C&A Marketing Returns Department
2 Bergen Turnpike
Reidgfiled Park, NJ 07660
Tel: 201-881-1900
Email [email protected]
www.myivation.com

Do not send any parts or product to C&A Marketing, Inc. without obtaining a Return Authorization Number and instructions. This warranty 
is VOID if instructions for use are not followed; for accidental damage; for commercial use; for damage incurred while in transit; or if the 
Ivation Wireless BBQ Thermometer has been tampered with. This warranty gives you specific legal rights and you may also have other 
rights which vary from state to state.

Distributed by C & A Marketing

2 Bergen Turnpike, Ridgefield Park, NJ 07660

[email protected]

Made in China

ivation is a trademark of  C&A IP Holdings, LLC

©2014 All right reserved

Summary of Contents for IVAWLTHERM






Reviews: