Preparation:
• Place the heater on a firm, level surface and plug into a grounded 120V, 60Hz power outlet.
• Only operate heater when it is in an upright position.
• Insert two AAA batteries into the remote control before using. Batteries are not included.
To add or replace the batteries, remove the battery cover from the remote. Do this by pushing down on the
arrow on the top of the battery cover and sliding it away from the remote. Insert two AAA batteries (not
included) and close the remote by sliding the battery covering back on to the remote.
Note: Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (NiCad,
Ni-MH, etc.) batteries.
Please note that infrared heaters do not heat or blow hot air like a traditional space heater. Infrared heaters
are intended to supplement an already-heated, insulated room. Square footage specifications assume a single
enclosed room, not an entire home. Infrared heaters do not heat through walls or floors, and are not intended
to replace a main heat source. Infrared heat can take at least 24 hours to warm a room, but they operate more
efficiently to maintain the desired temperature. Infrared heaters will not work well in uninsulated, unheated
spaces like screened-in porches, RV’s, garages, unheated basements, etc.
Control Panel:
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
17
16
1 Fan Indicator Light
Indicates when the Fan is active
2 Flame Effect Indicator Light
Indicates when the Flame effect is on
3 Timer
Indicator
Indicates when the timer function is active
4 Digital
Display
Readout of the set room temperature or timer value
5 Celsius Indicator Light
Indicates that the temperature is being displayed in Celsius
6 Fahrenheit Indicator Light
Indicates that the temperature is being displayed in Fahrenheit
7 Power Indicator Light
Indicates when the unit is receiving power from the wall outlet
8 Power Switch Button
Powers the heater ON or OFF
9 C/F
Button
Toggles between celsius and fahrenheit
10 Temp-Down Button
Decreases the set temperature
11 Temp-Up Button
Increases the set temperature
12 Timer Button
Engages the on/off timer function
13 Heater Mode Button
Toggles between Hi / Low / Eco Modes
14 Flame Effect Button
Toggles the Flame Effect ON / OFF
15 Energy Saver Indicator
Indicates when energy-saving mode is on
16 High Heat Indicator
Indicates when High Heat mode is on
17 Low Heat Indicator
Indicates when Low Heat mode is on
