CM5_WithAnybus_QM_9752090130_NL_D_GB_F_IT_V2_0
17
GB
Switching the mains voltage on/off
- Switching on
= Switch to position [ l ].
- Switching off
= Switch to position [ 0 ].
When switching on the generator, the limit indicator will flash for 2 seconds.
After 2 seconds the background lighting on the display will slowly illuminate and information will
be shown about the generator. This information includes:
-
The generator type (e.g. “
CM5-60N
”)
-
The firmware version
-
The set bus address
-
Additional information
This information is displayed for 2 seconds and then the generator continues to start.
When the generator is switched on for the first time or after the factory settings are reset, the
generator will first need to be set up via a quick configuration (‘initial setup’). In all other cases
the generator will start normally and the main menu will be displayed. The generator always
starts up in the mode that was active when the generator was switched off.
Configuring the generator via the ‘Initial setup’ menu
The ‘Initial setup’ or quick
configuration menu is used to quickly
configure the generator. The
generator can be used immediately
after configuration.
As soon as “
[Initial setup]
” appears
in the display, this means that the
generator still needs to be configured
for use.
Set the following parameters:
“
Language: English
”
Using the [ ] / [ ] keys, select until
the desired language option
“
English
”, “
Deutsch
”, “
Italiano
” or
“
Français
” flashes on the screen.
Then press [
] to confirm the
choice
. From now on, the selected
language will be used for operating the CM5. The following text will then appear:
“
Bus address: 126
”
Using the [ ] / [ ] keys, select until the desired bus address [1…125] flashes on the display.
Then press [
] to confirm the choice
.
“
Fieldbus source: Bus
”
Using the [ ] / [ ] keys, select until the correct option flashes on the screen. You can choose to
switch the output voltage on and off via the bus communication (“
Bus
”) or via the external
hardware input (“
External
”). Then press [
] to confirm the choice
.
The CM5 is now configured and can be used. The main screen of the CM5 will then be
displayed.
