ORBITALUM TOOLS GmbH
D-78224 Singen www.orbitalum.com
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
70
Servicing, maintenance, troubleshooting
GFX 3.0, GFX 6.6
eNGLISH
10.1.1 Line laser
X
Own maintenance work on the laser is not permitted.
X
The laser is to be returned to the factory for any maintenance or repair work that may be required.
X
It is not allowed to open, modify or to remove protective covers or housings except for battery change.
10.2 What to do if ...? – General trouble shooting
PROBLeM
POSSIBLe cAUSe
ReMeDY
The tube cutter will not turn.
The locking screw is tight.
X
Loosen the locking screw.
Incorrect tube dimension.
X
Set the tube dimension correctly.
The saw blade is not cutting and is
slipping through.
The nut on the saw blade shaft is not
tight enough.
X
Tighten the nut.
The saw blade is not cutting.
The saw blade has been inserted the
wrong way round.
X
Insert the saw blade so that the labeling
on the saw blade faces the tube cutter.
The tube is not cut concentrically.
The tube cutter has been incorrectly
flanged. The flange surfaces are
contaminated.
X
Remove the tube cutter, clean the fixing
parts and flange surfaces, reflange
the saw.
The tube is not cut.
Pipe dimension not correctly set.
X
Adjust the bevel cutter to the tube
dimension (chap. 8.6, p. 62).
The clamping lever is not tightened.
X
Tighten the clamping lever.
The motor does not start.
The auto startup inhibitor is active
because the ON switch is locked.
X
Release the locking button and press the
ON switch again.
10.3 Servicing/customer service
For ordering spare parts, refer to the spare parts list.
For troubleshooting, please contact the branch responsible directly.
Please indicate the following details:
• Type of machine: Pipe cutting and beveling machine
GFX 3.0
or
GFX 6.6
• Machine no.
(see type plate)
