LOVESHAW
an
ITW
Company
TROUBLE SHOOTING
9.
CHECK THE PRESSURE OF THE HEAD AGAINST THE BELTS AND HESITATE AS IT IS
BEING FED THROUGH THE MACHINE. ADJUST THE HEAD HEIGHT.
10.
CHECK THAT THE BELTS ARE NOT SLIPPING.
11.
CHECK ADJUSTMENT OF THE GUIDE PLATE AND FINGER PLATE.
5.
SHORT TAPE TAB ON BOX:
1.
CHECK TAPE TENSION.
2.
CHECK ROLLERS FOR BINDING.
6.
TAPE NOT BEING WIPED ON BOTTOM OF BOX:
THERE ARE LARGE ECCENTRIC STOPS THAT ARE FACTORY SET TO INSURE THAT FRONT
ROLLER ARM CANNOT BE DEPRESSED BELOW BOX HEIGHT. THEY ARE LOCATED INSIDE
CARTRIDGE ON BOTH SIDES. WHEN FULLY DEPRESSED, FRONT WIPE ROLLER SHOULD
PROTRUDE 3/32” ABOVE CARTRIDGE FRAME. IF THIS NEEDS ADJUSTING, ROTATE THE
ECCENTRIC STOPS. USE BOTH STOPS AND MAKE SURE ROLLER ARM CONTACTS FLAT
SURFACES. WHEN PROCESSING BOXES LESS THAN 5” HIGH, THE ECCENTRIC STOPS
MUST BE MOVED TO THE OPPOSITE HOLE IN THE CARTRIDGE FRAME. THE FRONT
ROLLER SHOULD THEN PROTRUDE TO BELT LEVEL.
7. TAPE
NOT
CUTTING:
1.
CHECK KNIFE ARM FOR MECHANICAL BINDING.
2.
CHECK THAT KNIFE IS NOT DULL.
3.
CHECK SPRINGS ON KNIFE STUDS.
4.
CHECK BUSHINGS IN KNIFE STUDS.
5.
IF KNIFE STOP BLOCK IS CAUSING FRICTION ON KNIFE STUDS, ROTATE UNTIL FREE.
6.
TAPE TENSION IS SET TOO LOW.
8.
TAPE NOT CENTERED ON BOX:
1.
USE SCREW IN CENTER OF TAPE CORE TO RE-ALIGN.
9.
TAPE NOT BEING WIPED:
1.
CHECK MAIN SPRING.
2.
TAPE TENSION IS SET TOO HIGH.
Summary of Contents for LOVESHAW LITTLE DAVID LD7D
Page 27: ......
