background image

PUMPS WITH FLEXIBLE CORD

1. Refer to instruction Manual P58671 or P48419 for installa-

tion of the pump.

2. If  your  pump  is  equipped  with  a  flexible  cord,  insert  the

115V  plug  into  a  properly  grounded  115V  outlet.  (see
Figure 6)

WARNING: ELECTRICAL SHOCK HAZARD
This pump is supplied with a grounded conductor. To

reduce the risk of electric shock, connect only to a properly
grounded,  grounding-type  receptacle.  Failure  to  follow
these instructions could result in serious personal injury or
death.

FIGURE 6

ITT
8200 N. Austin Avenue
Morton Grove, IL 60053
Phone: (847) 966-3700
Fax: (847) 966-9052
www.bellgossett.com

© Copyright © 2009 ITT Corporation
Printed in U.S.A. 10-09

THE ITT ENGINEERED BLOCKS SYMBOL AND
ENGINEERED FOR LIFE ARE REGISTERED
TRADEMARKS OF ITT MANUFACTURING
ENTERPRISES, INC.

Summary of Contents for Bell & Gossett Aquastat Series

Page 1: ...irculate water when the ON time conditions are met and when the water temperature is low enough to cause the aquastat to switch ON OPERATIONAL LIMITS For use on B G models NRF NBF Series PL indoor use only Power supply 115 120 VAC 60Hz 1Ø Minimum switch interval 15 minutes Run Modes ON continuous run OFF off at all times TIMER run at programmed intervals Maximum switch current 16 amps Aquastat swi...

Page 2: ...he aquastat is installed without the timer the steel cover is reassembled on the pump after the aquastat installation is complete 3 Fasten the aquastat clip to the discharge or suction pipe of the pump 4 Make the electrical connections according to the wiring diagram provided See Figure 1 5 Reassemble the conduit box cover to the conduit box while insuring that all wires are inside the box Reinsta...

Page 3: ...l to the I ON position 3 Program the ON OFF times by pushing the programming tabs toward the center of the dial for OFF operation and toward the outside of the programming ring for ON time periods A pencil pen or similar object may be used in making adjustments to the programming tabs 4 Set the manual switch to the TIMER position which is centered between the I and O on the timer dial in order to ...

Page 4: ...unded conductor To reduce the risk of electric shock connect only to a properly grounded grounding type receptacle Failure to follow these instructions could result in serious personal injury or death FIGURE 6 ITT 8200 N Austin Avenue Morton Grove IL 60053 Phone 847 966 3700 Fax 847 966 9052 www bellgossett com Copyright 2009 ITT Corporation Printed in U S A 10 09 THE ITT ENGINEERED BLOCKS SYMBOL ...

Reviews: