Replacing batteries
•
Turn off the
FS/GS
.
•
Remove the battery cap by using a suitable coin.
•
Do not allow rain or moisture into the battery
compartment.
•
Tilt the unit to slide out the batteries.
•
Slide the fresh batteries into the battery
compartment, positive end first. If you are fitting
AA size batteries, it is advisable to fit the packing
sleeve supplied with the
FS/GS
.
•
Refit the battery cap. Seat it with finger pressure
first and make sure that it has engaged the screw
threads before tightening it with a suitable coin.
•
Turn on and check operation.
•
If you can't turn on, contact your system provider.
•
After changing batteries, you
MUST
ensure that
the battery type, capacity and power
management are correctly set. (Refer to your
application's user instructions.)
CAUTION: If you have changed from
rechargeable to non-rechargeable batteries,
warn anyone you give the unit to. Non-
rechargeable batteries must NOT be recharged.
Always use batteries of the same type and
charge state - don't mix fresh batteries with used
batteries, or rechargeable batteries with non-
rechargeable ones. Observe the instructions
printed on the battery. Replace only with
batteries approved by your FS/GS supplier. DO
NOT FIT LITHIUM BATTERIES.
ATTENTION: Dispose of or recycle used
batteries according to the manufacturer's
instructions. Nickel-Cadmium rechargeable
batteries must be recycled, or disposed of
properly.
CAUTION: BATTERY CHEMICAL LEAKAGE IS
CORROSIVE. In the unlikely event of battery
leakage, do not touch. In case of accidental
contact, flush immediately with running water.
