ITOX SR960-N, User Manual

Page: 37 / 123

37
2
Hardware Installation
Front Audio Connector
X
The front audio connector allows you to connect to the line-out and
mic-in jacks that are at the front panel of your system. Remove the
jumper caps from pins 5-6 and pins 9-10 prior to connecting the
front audio cable connector. Make sure pin 1 of the cable connector
is aligned with pin 1 of the front audio connector. If you are not
using this connector, make sure to replace the jumper caps back to
their original pin locations.
BIOS Setting
Configure the onboard audio in the Chipset menu of the BIOS. Re-
fer to chapter 3 for more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
1 2
1 0 9
Mic GND
AuD_Vcc N. C.
AuD_R_Return
Key
AuD_L_Return
AuD_R_Out
N. C.
AuD_L_Out