REMOTE CONTROL RUNNER
USER MANUAL
6
3. DESCRIPTION OF ITEMS
Remote control, batteries and charger.
3.1. REMOTE CONTROL
It’s a sealed pushbuttons box made of highly resistant plastic material. On the front side you can find
the control buttons and LED indicators, and on the back side there is the housing for the
interchangeable batteries.
3.2. BATTERY CHARGER
The charger allows a fast and safe charging of batteries. The batteries supplied are Ni-MH and the
charger is designed to optimize
their charge and lifetime. It’s able to detect defective, short-circuited or
overheated batteries and can recover discharged batteries after a long period.
3.2.1. BATTERY CHARGING PROCESS
The charger has two indicator LEDs, one for power, which indicates that the device is connected to
power, and one for charging, which indicates that charging is in progress. When the battery is inserted,
the charger checks the charge level and depending on this it can perform two actions:
If the load level is low, a pre-charge is performed (LED flashing)
A constant charge is made for approx. 20 minutes (LED on steady).
After this time, the charger checks the state of the battery and adapts the charge to each case. When
the charging process is complete, the LED turns off. A complete charge is made in less than 3 hours.
The loading must be done at a temperature between -10 ºC and 50 ºC.
Before using the remote control for the first time, fully charge the batteries.
Manoeuvres and buttons on standard
Runner 9 remote control.
Manoeuvres and buttons on standard
Runner 11 remote control.
