4.1.2. Auto Night speed
The
Auto Night
speed setting raises the minimum
ventilation speed to ensure sufficient ventilation during
the night. This speed is determined, in part, by the
settings chosen for the number of floors and residents
(via the configurations settings menu). To ensure proper
operation of the
Auto Night
speed, it's important to
ensure that these settings have been properly configured.
You can set the unit to
Auto Night
when you go to bed in
the evening. Always ensure that the room grilles are open
when using this setting.
ä
Caution!
Auto-Night
does not switch off automatically after a
defined time. You should manually switch to
Auto
(or
another level) in the morning.
4.1.3. Dirty filter indication
The controller of the ventilation unit uses a smart counter
to keep track of when the filters need to be cleaned or
replaced. If the system detects that a filter is dirty, the
ventilation unit sends a wireless message to this effect.
This message can be displayed on specific linked devices.
Such as the CO
2
sensor, the RH sensor and the Spider air
conditioning thermostat.
The (dirty) filter indication is displayed by the status LED
on the sensor flashing orange.
4.1.4. Resetting filter indication
After cleaning or replacing the filters in accordance with
the instructions provided with the device, you should
reset the dirty filter indication:
You can reset the dirty filter indication in the following
way:
a) Disconnect power to the ventilation unit.
b) Apply power to the ventilation unit.
c)
Within 10 minutes, hold the touch button on the
sensor down for 5 to 7 seconds.
After a successful reset, the status LED flashes green 3x.
17
