6
80
120
10
13
24.2
22
28
15.8
□40
3
4.
1
⌀12 H8
M8
36
36
8.
4
4
M6
4
□40
3
4.
1
⌀12 H8
M8
36
36
8.
4
4
M6
4
□40
3
4.
1
⌀12 H8
M8
36
36
8.
4
4
M6
4
Side for machining the M6 thread
Tightening torque for the lock screws M8x16: 25 Nm
Carriage Profile
Grub screw
Adjuster Profile
Double-Bearing Unit
End Cap and Lubricating System
Slide LRF 8 D14 160x160/200x160
Once the support profile has been machined, prepared and connected with the
Shaft-Clamp Profiles, the guide carriage can be slotted into place on it.
Slot the carriage on before fitting the End Cap and Lubricating System (or
remove the latter first).
The LRF guide carriages in the various sizes as appropriate to the width of the
support profile are partially assembled. One Double-Bearing Unit is preas-
sembled ready for use, screwed firmly into place and cannot be adjusted. The
other Double-Bearing Unit is supplied with adjustment screws on the side that
protrude slightly.
Slot the guide carriage in its preassembled state onto the support profile that
you fitted the guiding Shafts to earlier.
Next, tighten the grub screws on the side alternately, making small adjustments
until there is no play between the Slide and guiding Shafts. Check the Slide unit
is free from play by pushing it along the entire length of the guiding Shafts and
make any adjustments that are necessary. Next, secure the position of the Dou-
ble-Bearing Unit from below using two Hexagon Socket Head Cap Screws M8.
Finally, install the End Cap and Lubricating Systems and Caps.
Slide Profile LRF 8 features two special grooves – one with an aperture width
of 10 mm, the other with an aperture width of 13 mm (see drawing). The groove
with the 13 mm aperture accommodates the play adjustment mechanism on
the slide. Play is adjusted by means of two threaded M6 through holes at the
side (see drawings) and two M6 grub screws.
Risk of mistaking the correct side for drilling!
Slide LRF 8 D14 160x160
