10
∅15
54
□
80
□
80
10
60
60
48
39
Hexagon Socket Head Cap Screw DIN 912 M4x16
Hexagon Socket Head Cap Screw DIN 912 M6x60
for connecting a Chain Reverse Unit
Hexagon Socket Head Cap Screw DIN 912 M5x12
Hexagon Socket Head Cap Screw DIN 912 M6x45
for connecting a Chain Reverse Unit
Connecting Drive Set 8 D40/D15 AP/WP 60 – 0.0.672.73
Drive Set 8 D40/D15 AP/WP 60 (0.0.672.73) is used solely to connect item
drives. The Drive Set is fully prepared for installation on the corresponding
Linear Unit. The drive shaft transfers drive torque without backlash. Hexagon
Socket Head Cap Screws DIN 912 M6x60 are supplied with the Drive Set for
this purpose and are screwed through the Coupling Housing of the Drive Set
and into the housing of the Chain Reverse Unit. Tightening torque: T = 13 Nm
The torques transferred by the clamp connection factor in the maximum mating
play for the shaft fits: Shaft k6 / hole H7. Force is transferred from the coupling
to the drive shaft by means of frictional resistance. The Shaft and the hole in
the coupling hub must be degreased and cleaned to ensure the frictional resist-
ance is effective. Hexagon Socket Head Cap Screws must be secured against
working loose. Hexagon Socket Head Cap Screws M6x20, T = 13 Nm.
Next, use the prepared Centring Piece to fasten the Gearbox flush on the
Adapter Plate of the Drive Set. Use Hexagon Socket Head Cap Screws DIN
912 M5x12 for this purpose (T = 10 Nm). Hexagon Socket Head Cap Screws
DIN 912 M4x16 (T = 6 Nm) are included in the Drive Set for the purpose of
fastening the Motor to the Gearbox.
Working through the Coupling Housing, create a friction-based connection
between the clamping hub screw (T = 9.6 Nm) of the clamp coupling half and
the drive shaft.
Expanding hub coupling D15 mm
Basic unit
Slide Stop
Slide Stop LRE 8
The robust aluminium Slide Stop LRE 8 stops the carriage on a Linear Unit
travelling past the calculated or desired point, and also acts as a homing point
for the system. Thanks to its special shape, the Slide Stop can be used with
shafts in various diameters and fitted at any position.
Note:
When configured using item MotionDesigner
®
, most LRE-type Linear
Units from item are automatically fitted with a Slide Stop that can be moved
to a different position or removed entirely, as required. Some models, such as
Linear Units KLE, are designed in such a way that an additional Slide Stop is
unnecessary.