8
www.itec-audio.com
MICROPHONES
ITEC 5100 WIRELESS SYSTEM
1. Antenna
2. Batterie weak
3. Mini-XLR connector
4. Power on/off switch
5. LCD display
6. Charging port
7. Charging contacts
8. Lavalier microphones (optional)
9. Mic clip (optional)
4. Pocket transmitter WT-5100 (UHF)
4.2 Batteries
The WM-5100 is powered by 2 batteries of the type AA.
Please note, that in case of a battery exchange both batteries must be
replaced by a similar type at once. Be careful when inserting the batteries
and check the correct polarity: For both batteries the negative pole has
to point towards the microphone cap. The battery condition is shown
on the LC display. The red battery indicator gives information on the
battery status as well: When turning on the system the indicator shines
for about one second. A permanent signal is a warning for a low battery
condition.
Remark
Used batteries are hazardous waste and have to be disposed accordingly. Some batteries (in particular low-end
products) can leak after long storage period and cause corrosion and ruining of the battery contacts. Use high
quality alkaline batteries of known brands, which also offer a longer lifetime.
9
1
2
3
4
5
6
8
7
12
13 14
15 16
12. Set
13. Up
14. Down
15. GT level adjustment for line-in (guitar)
16. MT level adjustment for microphone
4.1 Suitable connection cable respectively microphone
The pocket sender WT-5100 can be connected to the line-out socket of other audio equipment via the
adaptor cable ITEC-MC12.A lapel microphone (Lavalier microphone, button microphone), which is suitable to the
WT-5100 the ITEC-MC-12 is offered. Head sets are available in various variants, e.g. ITEC-MI and accordingly
ITEC-MC.