ENGLISH
15. USE EYE PROTECTION.
Use a full-face mask
if the work you’re doing
produces metal filings, dust or wood chips.
Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of fine
or coarse dust.
16. SECURE WORK.
Use clamps or a vise to hold the work. It’s safer than using
your hands and it frees both hands to operate the tool.
17. DON’T OVERREACH.
Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
18. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles
dry, clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING.
Be sure the switch is in the
OFF
position before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES
before turning the tool on. Left attached, these parts can fly
off a rotating part and result in personal injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF.
Have your tool repaired before using it.
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS.
Changing attachments or accessories can be dangerous
if the tool could accidentally start.
23. STAY ALERT.
Watch what you are doing & use common sense. Don’t operate
any tool when you are tired.
24. CHECK FOR DAMAGED PARTS.
Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate prop-
erly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mountings, and other conditions
that may affect its operation. Inspect screws and tighten any ones that are
loose. Any part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in the instruction
manual. Have defective switches replaced by an authorized service center.
Don’t use the tool if switch does not turn it on and off properly.
25. REPLACEMENT PARTS.
When servicing, use only identical replacement
parts.
26. SERVICE AND REPAIRS
should be made by qualified repair technicians at an
authorized repair centre. Improperly repaired tools could cause serious shock
or injury.
!
GUARD AGAINST ELECTRIC SHOCK.
When cutting wherever “live”
electrical wires may be encountered, hold the tool only by the plastic handle
to prevent electric shock.
DO NOT TOUCH ANY METAL PARTS OF THE
TOOL
. If you contact a live wire, the exposed metal of the saw becomes live
as well, and can shock the operator.
!
OBSERVE PRECAUTIONS WITH REGARD TO LASER.
This tool is
equipped with a laser to indicate where the cut line will be. Be sure to read
the precautions for the laser device in this manual, below.
!
DO NOT START THE SAW WITH THE BLADE IN CONTACT WITH ANY
SURFACE.
The reciprocating action will cause the saw to bounce violently
and could cause injury.
!
BE SURE THE WORKING AREA IS CLEAR OF ALL OBSTACLES
,
particularly on the other side of the material being cut.
!
IF MAKING A CUT USING ONE HAND TO HOLD THE SAW
,
ensure the free
hand is clear of the cutting area.
!
LET THE SAW COME TO A STOP
before putting it down. The reciprocating
action could cause the saw to jerk violently if it contacts anything with the
blade tip.
IMPORTANT SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS FOR JIGSAW with LASER
