ENGLISH
FRANÇAIS
6
WARNING:
Prior to inspection or saw maintenance, turn off power switch and
disconnect plug from power source.
Keep the tool housing and handle clean and free of oil and grease using mild
soap and a damp (not wet) cloth. Do not let solvents like brake fluid, gaso-
line, petroleum-based products, etc., contact plastic parts of the housing.
Cleaning with these substances can harm the plastic and compromise the
integrity of the double insulating system.
Inspect the mounting screws regularly. They should be properly tightened. If
any are found loose, tighten immediately or serious injury could result.
Use care to see that the motor winding does not become damaged or wet
with oil or water.
The carbon brushes should occasionally be checked and replaced if worn.
Worn brushes could cause motor damage and should be replace with identi-
cal parts if worn to or near their limit. Brushes should be kept clean and free-
moving within their holders.
Keep the vents clear of dust and debris. This will help prevent possible elec-
tric shorts and ensure proper cooling.
Avoid overloading your saw. Do not force the tool, otherwise it will become
hot and lose efficiency. Running it free of load for a minute or two will allow it
to cool itself to normal temperature.
Inspect the cord regularly and have it replaced by an authorized repair facility
if it is damaged.
Lubrication for this tool is done at the factory and should not be necessary
again under normal use.
An authorized repair centre should do any repairs, modification, or mainte-
nance that involve opening or disassembling the saw.
WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed
for use in DIY (do-it-yourself), light or intermittent duty, semi-professional
applications. They are not intended for use in professional, production, industrial
or continual use applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers’ faults and
defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by
the company to be defective, provided that it is has not been misused, abused,
altered, or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine
those products that are covered by our over-the counter warranty. Any ITC tool
that fails during normal use and within the specified warranty period and qualifies
for over-the counter warranty must be returned to its point of purchase for
replacement or credit. Any item not listed as over-the-counter warranty must be
shipped, prepaid freight, to an authorized repair depot accompanied by a copy of
the invoice specifying the date that the item was purchased. Returned tools that
are not accompanied by a proof of purchase (Copy of Invoice) will not be repaired
or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad
and staple gun driver blades, grinding discs, saw blades, driver bits, electric
motor brushes, worn chords, etc. It also does not apply to ITC tools used in
professional, production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
MAINTENANCE
!
