connector, it must be set to the non-active state in the target via a pull-up resistor. If not then
the JTAG TAP state machine remains in reset and debugging is not possible.
Signal direction definition:
O - Output from the Active Probe to the target microcontroller
I - Input to the Active Probe from the target microcontroller
B
– Trigger connector – Provision for future functional extensions. No functionality at the
moment.
C
– The indicator light provides the status of the Active Probe as follows:
·
Permanently green - Powered On and ready
to use.
·
Blinking green - Establishing connection
with the BlueBox.
·
Blinking blue - Reprogramming SPLASH.
·
Permanently magenta - Golden image
loaded and ready to use.
D
– FNet connector, that connects the Active Probe to the iC5700 BlueBox. The FNet cable is
delivered with the Active Probe.
When powering on the system, switch the iC5700 on before powering on the target
system. When powering down the system, power off the target before powering off the
iC5700!
FBridge port is not Ethernet port!
Use only original iSYSTEM accessories for powering and connecting with the iC5700.
Consult with iSYSTEM before attempting to use any other accessory.
Target connector
The target should feature a matching part, for example, Samtec part number: ASP-137973-01.
