Further Active Probe Settings
This section describes winIDEA settings distinct to the MPC5x/SPC5x Active Probe.
Alternatively, the iC5700 is capable of connecting to MPC5xxx and SPC5 target devices
through its installed DTM module and an appropriate debug adapter
·
14-pin 2.54mm MPC5xxx Debug Adapter (Ordering code IC50150) or
·
38-pin Mictor MPC5xxx Nexus 16-bit D. Adapter (Ordering code IC50152)
In order to switch from the default DTM interface use to the Active Probe use, open
Hardware
menu / Options / FNet tab
:
1. Click Refresh in Hardware menu / Options / FNet / Currently connected FNodes.
2. Click Create configurations for connected FNodes. Selected device is displayed in FNode
configurations
.
Configuration is created. Look for:
·
Listed devices with Matched FNode
·
Y (for yes) under Matched config
·
List of available networks
